 |
Excellent for curing |
|
|
One time permanent application |
|
|
Easy and safe to apply |
|
|
Can penetrate beyond 200mm |
|
|
Waterproofs inside and outside |
|
|
Preserves concrete’s integrity |
|
|
Makes concrete more durable |
|
|
Easy snow/ice removal |
|
|
Low slip, buffable coating |
|
|
Prevents efflorescence
|
|
|
|
HOW TO APPLY:
For newly placed unused concrete only. For existing, used and old
concrete a two part system must be used. Densi-Proof™ will
decontaminate and purge deep seated unwanted substances to the
surface and these need to be removed prior to finishing with the
surface sheen.
Note: In hot climates, mist-wet the
surface with water and remove any puddles prior to application.
-
Use low pressure airless
sprayer complete with 60cm wand and a .019” fan tip spray jet.
-
Hold spray tip a minimum 150mm
from surface.
-
With an overlapping spray
pattern of 50%, achieve a rate between 4.5 - 9.0m2 per litre.
Rate will depend on the porosity or openness of the concrete.
-
Begin applying at the lowest
level elevation. For example, walls and slopes should be applied
side to side, from the bottom up.
-
Before the coating dries,
using a short nap paint roller, push excess product form the low
points in the floor and evenly distribute back over the higher
spots. This will also give a higher finished sheen.
|
|
|
OTHER IMPORTANT NOTES:
Use only on green or recently placed concrete. Densi-Proof™
plus Surface Sheen™
will seal in visible stains and bring hidden contaminants to the
surface of old contaminated concrete and seal them in.
-
Wax, paint or
any thing else restricting access to concrete’s interior must be
chemically or mechanically removed for PROTECT CRETE®
Densi-Proof™ plus Surface Sheen™ to penetrate.
-
Areas of high
porosity have a faster penetration rate. These areas appear dry
immediately after spraying and will require additional product.
-
Do not apply on
frozen substrate or when temperature is near freezing.
-
PROTECT CRETE®
Densi-Proof™ plus Surface Sheen™ may etch glass or dull brushed
and shiny aluminium and can be difficult to remove from other
surfaces once it dries. Cover and mask surrounding surfaces or
rinse immediately if sprayed.
-
We recommend
the use of a painters mask during application. Refer to MSDS.
-
Ensure you
contact your nearest PROTECT CRETE® office for full technical
bulletins and latest application procedures.
|
|
