-
Preserves original colour of surface with a
satin look
-
Easy and safe to apply
-
Can be used on a wide variety of surfaces
-
Provides extra strength, integrity and
flexibility
-
Easier snow/ice removal
-
Remains resilient
-
Enhances surface traction
-
Resists fungus and mildew
-
Long Lasting
-
Can be coloured with acrylic pigments
|
|
Ready to Use
DO NOT DILUTE |
|
|
HOW TO APPLY AS A
PROTECTIVE COATING:
Note: Always start with a clean
bare surface. Remove all dirt, stains, glues and previous coatings.
If you don’t they will be preserved for the
life of the coating.
-
Using a short nap paint roller, apply evenly
and thinly at the rate shown on the chart. Do not over apply or
allow to puddle.
-
Allow at least 24 hours to dry thoroughly. May
require more drying time in high traffic areas.
-
May be burnished to a higher sheen with high
speed machine with animal hair pad. Contact your nearest PROTECT
CRETE® office for details.
|
|
ESTIMATED M2
PER LITRE |
Render
Concrete
Brick
Pavers
Clay Tile
Grout
Limestone
Stucco
Slate |
5 - 7
4.5 - 7
7 - 12
7 - 11
9 - 16
7 - 16
4.5 - 7
7 - 16
9 - 11 |
|
|
HOW TO USE AS A SAND CONSOLIDATOR:
-
Use low pressure non-atomising
spray unit.
-
Apply uniformly over pavers
and sand at the rate shown in the table
-
Use small squeegee to wipe
excess product from paver tops into sand joints.
-
Do not allow surplus pooled
product to air dry on pavers
OTHER IMPORTANT NOTES AND
PRECAUTIONS:
-
Protect areas not intended for
coverage as product is very difficult to remove when dry.
-
When used as a coating Surface
Save & Seal™ must be applied in a thin layer, otherwise the
strength of the bond will be compromised. For a thicker layer
apply subsequent coats 24 hours after each application.
-
Surface Save & Seal™ will
adhere to the first surface it meets, including dirt. If product
adheres to dirt. it may peel up. If this occurs, peel away the
weak areas, clean the surface and reapply.
-
Surface Save & Seal™ has a
minor almost insignificant trace of VOC.
-
Incidental skin contact should
not be hazardous, but ingestion or eye contact should be
avoided.
-
We recommend use of a painters
mask during application.
-
Do not apply to surface in
full sun or if temperature is over 24°C.
-
Refer to MSDS
|
|
