 |
Prevents negative chloride ions reaching reo |
|
|
One time permanent application |
|
|
Easy and safe to apply |
|
|
Can penetrate beyond 200mm |
|
|
Halts internal migration of water |
|
|
Easy and Safe to apply |
|
|
Preserves concrete’s integrity |
|
|
Makes concrete more durable |
|
|
Prevents efflorescence
|
|
 |
|
HOW TO APPLY:
Note: In hot climates, mist-wet the surface with water and remove
any puddles prior to application.
-
Use medium to
high-pressure airless sprayer complete with 60cm wand and a
.019” fan tip spray jet.
-
Hold spray tip
150mm from surface.
-
Apply at point of
saturation twice in back to back applications. To do this,
visually establish start and finish points during the first
application, then reapply over the same area again using the
original start finish points as a reference.
-
Use overlapping
patterns of north/south for the first coat and east/west for the
second coat. In other words the second coat must be applied at
right angles to the first. Each application should be at the
rate of 4.5m2 per litre with an overlapping spray pattern of
50%. Therefore estimate volume needed at the rate of 2.25m2 per
litre.
-
Begin applying at the lowest level elevation. For
example, walls and slopes should be applied side to side, from
the bottom up.
|
|
Ready to Use
DO NOT DILUTE |
|
|
OTHER IMPORTANT NOTES:
-
Wax, paint
or any thing else restricting access to concrete’s interior must
be chemically or mechanically removed for PROTECT CRETE
Densi-Proof plus Reo Protect to penetrate.
-
Areas of high
porosity have a faster penetration rate. These areas appear dry
immediately after spraying and will require additional product.
-
Do not apply
on frozen substrate or when temperature is near freezing.
-
When applying
paint, adhesives or any other coatings, wait 24 hours after
sealing with PROTECT CRETE Densi-Proof plus Reo Protect, then
flush clean surface with water and allow to dry before coating.
Always follow coating manufactures surface requirements.
-
PROTECT CRETE
Densi-Proof plus Reo Protect may etch glass or dull brushed and
shiny aluminium and can be difficult to remove from other
surfaces once it dries. Cover and mask surrounding surfaces or
rinse immediately if sprayed.
-
We recommend
the use of a painters mask during application. Refer to MSDS.
-
Ensure you
contact your nearest PROTECT CRETE office for full technical
bulletins and latest application procedures.
|
|
