-
Provides an attractive sheen finish
-
Can be used on a wide variety of surfaces
-
Minimises acid and chemical attack
-
Provides extra strength, integrity and
flexibility
-
Long Lasting
-
Easy and Safe to apply
-
Consolidates and waterproofs the sand between
pavers
-
Enhances traction lowers slip potential
-
Excellent oil, chemical, acid and water
repellence
|
|
Ready
to Use
DO NOT DILUTE |
|
|
HOW TO APPLY AS A PROTECTIVE COATING:
Note: Always start with a clean bare surface. Remove all
dirt, stains, glues and previous coatings.
If you don’t they will be preserved
for the life of the coating.
-
Using a short nap paint roller, apply evenly
and thinly at the rate shown on the chart. Do not over apply or
allow to puddle.
-
Allow at least 24 hours to dry thoroughly. May
require more drying time in high traffic areas.
-
May be burnished to a higher sheen with high
speed machine with animal hair pad. Contact your nearest PROTECT
CRETE® office for details.
|
|
ESTIMATED M2 PER LITRE |
Concrete
Brick
Pavers
Clay Tile
Grout
Limestone
Stucco |
4.5 - 7
7 - 12
7 - 11
9 - 16
7 - 9
4.5 - 7
7 - 16 |
|
|
HOW TO USE AS A SAND CONSOLIDATOR:
-
Use low pressure non-atomising spray unit.
-
Apply uniformly over pavers and sand at the
rate shown in the table
-
Use small squeegee to wipe excess product
from paver tops into sand joints.
-
Do not allow surplus pooled product to air
dry on pavers
OTHER IMPORTANT NOTES AND
PRECAUTIONS:
-
Protect areas not intended for coverage as
product is very difficult to remove when dry.
-
When used as a coating Luster Shield™ must be
applied in a thin layer, otherwise the strength of the bond will
be compromised. For a thicker layer apply subsequent coats 24
hours after each application.
-
Luster Shield™ will adhere to the first
surface it meets, including dirt. If product adheres to dirt. it
may peel up. If this occurs, peel away the weak areas, clean the
surface and reapply.
-
Luster Shield™ has a minor almost
insignificant trace of VOC.
-
Incidental skin contact should not be
hazardous, but ingestion or eye contact should be avoided.
-
We recommend use of a painters mask during
application.
-
Do not apply to surface in full sun or if
temperature is over 24°C.
Refer to MSDS
|
|
